The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Reply
 
Thread Tools
Old December 5, 2008, 02:18 PM   #1
oldwheat
Senior Member
 
Join Date: June 28, 2005
Location: Dorton's Station
Posts: 105
R&D cylinder w/ Kirst backplate?

Has anyone attempted this? Theoretically it should be achievable with a little tweaking & fitting. It would be kinda nice to to have a 6 shot capability & a loading gate. Of course I realize that the original factory conversions didn't have a loading gate or back plate anyway, at least I never did see one.
oldwheat is offline  
Old December 5, 2008, 04:11 PM   #2
grymster2007
Senior Member
 
Join Date: May 22, 2007
Location: In the oak studded hills near Napa
Posts: 2,203
I'm not entirely sure how the Kirst works, but this does not look simple. The timing features (ratchet) of the Kirst are machined into the cylinder rather than into the backplate as in the R&D. Thus, the R&D cylinder is of no use. Also, while I don't have a Kirst, there might be a good reason why they only hold five.

Sounds like a non-starter to me.
__________________
grym
grymster2007 is offline  
Old December 5, 2008, 06:22 PM   #3
Raider2000
Senior Member
 
Join Date: July 23, 2007
Location: Virginia
Posts: 717
The Kirst conversion cylinders for the 1858 Remington Revolvers are very close to the original design that Remington used during the late 1860's & early 1870's.

The reason that the cylinder only allowes 5 shots & a dead spot is because of the rim size of the .45 Colt round like the old .46 Remington or .44 Colt is just slightly too large to allow 6 rounds to be loaded into the cylinder with the chambers straight bored like the Kirst & original conversions are.

The R&D conversion cylinders are Bored at a 5/8 of one degree to allow the 6th chamber to be loaded with a live .45 Colt cartridge & is Mr. Howell's patented design.

The Gated setup that Kirst offers is nice but was never done by Remington & does require some modification to the revolver to make the gate work like it's supposed to.
Raider2000 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:38 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05608 seconds with 7 queries