The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old November 29, 2008, 03:22 PM   #1
WSM MAGNUM
Senior Member
 
Join Date: September 30, 2006
Location: Maryland
Posts: 746
Recoil Pad Repair

The screws for the recoil pad on my Remington SP-10 are stripped out. They no longer have any wood to bite into. So I was thinking to glue in wood dowels to fill in the holes and then re-drill the holes again.
My main reason for posting this is, this is the second gun where the recoil pad screws stripped out on me. Is this a problem that most guns have when you try to remove the pads? I think the factory is drilling the holes in the wood a little too big.
What are your experiences with the pads on your guns?
__________________
Henry - Life NRA Member, USCCA Shield Member

If con is the opposite of pro, is Congress the opposite of progress?
WSM MAGNUM is offline  
Old November 29, 2008, 07:52 PM   #2
Pahoo
Senior Member
 
Join Date: February 16, 2006
Location: IOWA
Posts: 5,678
This is the usual repair and woodworker's supply even make a taper tool and provides the plugs. The plugs are tapered like a pencil point. I have only seen this problem on older guns and seems to be mostly what they call dry rot in wood. However, I have seen some Remingtons that have a great stock finish but raw wood under the butt plate. I sometimes coat these butt ends with epoxy or a good spar varnish. Take care to mark and drill the new holes as your butt plate won't be veryy forgiving. I know some folks to put beeswax on the threads of the mounting screws and other put epoxy, I guess in part to seal this area as well. I use beeswax. Understand that I am not a gun smith but a tinkerer. I do build M/L,s and rework stocks. Good luck..



Be Safe !!!
Pahoo is offline  
Old November 29, 2008, 08:35 PM   #3
Doyle
Senior Member
 
Join Date: June 20, 2007
Location: Starkville, MS
Posts: 4,977
If you don't feel like drilling out and doweling, you can try the toothpick trick. Get a toothpick and cut the tips off about 1/2 inch from each end. Dip the pointy ends in wood glue and stick them into the screw holes (2 to the hole. Now, put a little wax on the screw and screw them into the holes almost as deep as they would go with the pad on. After letting it dry for about 2 days, gently remove the screws and try to screw on the recoil pad.
Doyle is online now  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:06 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07283 seconds with 9 queries