The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old November 27, 2008, 09:46 PM   #1
zombieman
Member
 
Join Date: November 27, 2008
Posts: 25
Remington 700 iron sights (installation?)

I was wondering. I have a rem 700 7mm mag which doesn't have iron sights on it. Can a smithy install them even if the rifle doesn't have any obvious place for them. (meaning drilling holes and fitting the sights to the gun). All thats on the rifle is a scope and it would sure be nice to add iron sights. Thanks.
Attached Images
File Type: jpg rifle1.JPG (197.2 KB, 154 views)
File Type: jpg rifle2.JPG (195.2 KB, 125 views)
File Type: jpg rifle3.JPG (203.7 KB, 109 views)

Last edited by zombieman; November 27, 2008 at 10:24 PM.
zombieman is offline  
Old November 27, 2008, 11:26 PM   #2
kraigwy
Senior Member
 
Join Date: June 16, 2008
Location: Wyoming
Posts: 9,513
Yes it can be done easily. If the barrel is two thin to tap and drill for the front sight it can be sweated (silver soidered) on. The rear sight also unless you want a Lvman or Williams reciever sight. I believe your M-700 is already taped for them.

Below is a picture of a Model 700 I put irons on. I use apeture sights so I put on a sight block on the front and Redfield target sights on the rear. Like I said the 700 is already drilled and tapped for the reciever sights.

__________________
Kraig Stuart
CPT USAR Ret
USAMU Sniper School Oct '78
Distinguished Rifle Badge 1071
kraigwy is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:44 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05568 seconds with 8 queries