The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old November 11, 2008, 10:36 PM   #1
bclark1
Senior Member
 
Join Date: January 5, 2005
Location: Ohio
Posts: 1,531
Sig P226 FTE Solution?

So I still love my P226 CPO, but it's not fit for nightstand service because of some reliability issues. Specifically, it's been failing to eject a few rounds per hundred the past two range visits. It's not a stovepipe or partial extraction - the case will remain in the chamber, the slide will cycle, and a fresh round will be pushed into the back of the empty for the jam-up. The weapon is regularly maintained and properly lubricated. It does not fail on any particular round throughout the magazine, it just seems to occur at random.

Any suggestions on what the culprit could be for random occasional empties left in chamber in a P226 9mm?
bclark1 is offline  
Old November 11, 2008, 10:52 PM   #2
Nnobby45
Senior Member
 
Join Date: November 20, 2004
Posts: 3,148
Improper extractor tension, or broken extractor if it isn't pulling it out of the chamber reliably. The new generation P226's have an external extractor which provides easy access so you can change it out with a little training. Early generation with internal extractors are more involved. Or send the gun back.

Note: Some old models with internal extractors don't get cleaned inside the extractor tunnel (no access),and carbon can build up inside between the extractor and the breach block insert so it can't flex. You can try soaking the whole slide (not the sights) in solvent over night and blow it out good with canned air.

Broken extractors I've seen usually break so that they won't extract at all. Since yours is random and it usually extracts, I'd suspect tension. Solution is probably a new extractor if it's a new generation.

Easy enough to determine:

With the slide off the gun and barrel removed, you can insert a round up under the extractor and see if it stays there when you shake the slide a little bit, and rotate it. It will likely be too loose. Also inspect the extractor to see if the hook is damaged.

Last edited by Nnobby45; November 11, 2008 at 11:00 PM.
Nnobby45 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:32 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05460 seconds with 7 queries