The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old October 25, 2008, 10:06 PM   #1
dabigguns357
Senior Member
 
Join Date: May 3, 2008
Location: Ona,West Virginia
Posts: 1,215
new pistol grips

I wanted know how to take off my old pistol grips and replace them with new ones i have ordered from the S&W shop.

dabigguns357 is offline  
Old October 28, 2008, 08:28 AM   #2
Bruce H.
Member
 
Join Date: January 18, 2008
Posts: 22
You have to take a punch and hammer and remove the pin at the bottom rear of the grips. You can see the pin in your picture. This pin also retains the mainspring or hammer spring so be aware of that. Once you have removed the pin, lift the grip panel up at the rear and pull towards the rear. There is a notch that retains each grip panel on the front edge. It is not difficult, I replaced the grips on my Model 915 about a year ago.
Bruce H. is offline  
Old October 28, 2008, 03:32 PM   #3
dabigguns357
Senior Member
 
Join Date: May 3, 2008
Location: Ona,West Virginia
Posts: 1,215
Thanks Bruce i'll get right on it.
dabigguns357 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:12 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05654 seconds with 7 queries