The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old October 5, 2008, 11:44 AM   #1
Senior Member
Join Date: August 15, 2007
Posts: 1,040
Browning recoil pad removal

What size/type of screws hold the recoil pad on a BPS? I see the slits in the rubber where the screws should be but I can't tell what they are by feel . Thanks.
ActivShootr is offline  
Old October 6, 2008, 01:42 AM   #2
Senior Member
Join Date: September 26, 2008
Location: Idaho- Where Else?
Posts: 130
I believe most of the recoil pads I've delt with were a large phillips head, but you'll just have to get in there with a couple different screw drivers and figure out which one fits into the screw. using an assembly type lube really helps when installing or removing pads, as it keeps the rubber from grabbing the driver, and helps get the screw out/in. Brownells sells it, but something similar, like a vynal conditioner would probably work too.
NormOps is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 04:17 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04673 seconds with 9 queries