The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old September 27, 2008, 10:45 PM   #1
2ndchance
Senior Member
 
Join Date: March 21, 2008
Location: Glendale, AZ
Posts: 156
Removing/Swapping out 2011 grips for my STI

Hello All.

I'm installing a short trigger on my STI 2011 Tactical 4.15. I'm running into a bit of trouble getting the polymer grip off the aluminum frame.

1. Cleared weapon. Removed complete upper.
2. Removed the mag well and mainspring housing.
3. Removed the two allen screws on the trigger guard.
4. Removed the two top grip screws.
5. Removed the magazine release.

I assumed that the aluminum frame, at this point, should just lift off. I assumed so, because I can't see a way to remove the ambi safeties without removing the frame from the grip.

A little help please.
__________________
"It's better to be prepared, than scared."

Explaining the 2nd Amendment
2ndchance is offline  
Old September 29, 2008, 12:50 AM   #2
2ndchance
Senior Member
 
Join Date: March 21, 2008
Location: Glendale, AZ
Posts: 156
Never mind. Found some instruction on Brian Enos' web site.
__________________
"It's better to be prepared, than scared."

Explaining the 2nd Amendment
2ndchance is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:03 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05490 seconds with 7 queries