The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old August 19, 2008, 06:38 PM   #1
bswiv
Senior Member
 
Join Date: June 4, 2006
Location: NE FL.......
Posts: 1,081
Old firing pin question?

I have a F. Dumoulin 16 ga boxlock that was made in the 50s. It needs a right side firing pin..........at least that's what I think is wrong.

Where do I find such?

Could I take it to a local machine shop and have one made? Would they have the proper steel?
bswiv is offline  
Old August 19, 2008, 09:22 PM   #2
Dfariswheel
Senior Member
 
Join Date: May 4, 2001
Posts: 6,819
You might contact the factory direct.
They should have an importer and repair service here that can supply and fit an original factory part.

http://www.dumoulin-herstal.com/en/fusil.htm
Dfariswheel is offline  
Old August 20, 2008, 03:18 AM   #3
bswiv
Senior Member
 
Join Date: June 4, 2006
Location: NE FL.......
Posts: 1,081
Thank you.

I sent them a email this morning. Hopefully a positive responce will follow.
bswiv is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:41 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06737 seconds with 9 queries