The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old April 19, 2008, 06:44 PM   #1
Glanz
Junior Member
 
Join Date: April 15, 2008
Posts: 4
Factory Crimp Die for a 270 Weatherby

I am curious if anyone has had any success in ordering a custom made Lee factory crimp die. They don't make the die in the caliber I am reloading so I have to have one custom made. Is there another option for a crimp only die for the 270 weatherby or other uncommon calibers? I just don't want to wait 6 months for this crimp die to show up. I purchased a seating/crimping die from Hornady and wasn't too impressed with it so I figured I would split it up into two steps to make sure I get it right.

My other question relates to crimping as well. I am under the impression that you don't crimp a smooth bullet but you do crimp a bullet with a cannelure. When you don't crimp, how secure is the bullet really? I seated a smooth 150 grain bullet in a casing and cycled it through my rifle a few times. It seemed to stay in place fine but if I were to push on the tip of the bullet, I could easily push it all the way into the case. Is this normal or should it be a lot more secure? Most of my shooting is done at the range so I guess if I could avoid crimping, that would be better for my brass.

Thanks in advance, these forums have been very helpful.
Glanz is offline  
Old April 19, 2008, 07:04 PM   #2
jaguarxk120
Senior Member
 
Join Date: February 28, 2008
Location: Michigan
Posts: 1,943
You do not need to crimp the bullet unless your shooting a lever action with a tubliar magizine. If you can push the bullet into the case there's a problem with your sizer die or the expander button.
I don't think is nessary unless your shooting a heavy recoiling rifle or revolver.
TF
jaguarxk120 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:07 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05178 seconds with 7 queries