The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Reply
 
Thread Tools
Old February 25, 2008, 06:28 AM   #1
Reliabilityman
Member
 
Join Date: December 6, 2007
Posts: 23
Stripping Out Clean out Plug on Hawkins

On occasion, when disassembling for cleaning, I often have problems stripping the flats on the cleanout plug. Is there a special small screwdriver to take these out. I usually get a couple of years out of a plug before it gets bad. But last night after going to the range, the plug was really stuck. After just about messing it up and a lot of cursing, I finally got it out, but the flats on plug are deformed and stripped so I have to buy another one. Anyone have a trick they can share? How did a mountain main take this plug out 160 years ago in the wilderness?

Thanks
Reliabilityman is offline  
Old February 25, 2008, 06:55 AM   #2
mykeal
Senior Member
 
Join Date: October 8, 2006
Location: Northern Michigan
Posts: 2,754
Well, yes, I think there is.

I'm going to recommend a set of gunsmith's screwdrivers, although if this is the only screw you're having a problem with the solution is a bit expensive.

Brownell's, among others, sells gunsmith tools. Chapman's is a good quality set and it should contain the one you need. I would imagine you can find a smaller set for less money, but this one is a good assortment, so the odds of it having the bit you'll need are quite good.

http://www.brownells.com/aspx/NS/sto...EWDRIVER%20SET

Also, if you're not already doing so, consider using some thread anti-seize compound on the screw threads. I use Thompson Center's Bear Grease - there are lots of good alternatives.

Last edited by mykeal; February 25, 2008 at 06:56 AM. Reason: Add anti-seize comment
mykeal is offline  
Old February 25, 2008, 08:01 AM   #3
Hawg Haggen
Senior Member
 
Join Date: September 8, 2007
Location: Mississippi
Posts: 11,649
Quote:
How did a mountain main take this plug out 160 years ago in the wilderness?
I kinda doubt they did. Course I wasn't there so it's just speculation on my part. I have an Investarms Hawken that's 30 some years old and I've never seen the need to remove it. I seriously doubt it would come out now.
Hawg Haggen is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:50 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06683 seconds with 7 queries