The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Reply
 
Thread Tools
Old February 23, 2008, 09:52 PM   #1
hunter64
Member
 
Join Date: June 5, 2007
Posts: 53
Does Lyman RB molds leave a sprue when poured

I have the Lee RB mold for my revolvers and it leaves a flat where the sprue is cut, is a lyman mold better?
hunter64 is offline  
Old February 23, 2008, 10:01 PM   #2
Hawg Haggen
Senior Member
 
Join Date: September 8, 2007
Location: Mississippi
Posts: 11,639
They all do that. Balls without a sprue are swaged.
Hawg Haggen is offline  
Old February 24, 2008, 10:48 AM   #3
Pahoo
Senior Member
 
Join Date: February 16, 2006
Location: IOWA
Posts: 5,453
Hawg Haggen +1

Round balls are very forgiving and the sprue area will not pose any problems. I always load my balls sprue up. Might suggest you weigh them to insure consistancy. Be Safe !!!
Pahoo is offline  
Old February 24, 2008, 11:11 AM   #4
Jbar4Ranch
Senior Member
 
Join Date: May 19, 1999
Location: Near Helena, Montana
Posts: 1,537
I've found that Lee moulds leave a less pronounced sprue than Lyman, but all cast balls will have a sprue. I've also found that positioning of the sprue when loading doesn't have a very dramatic effect on accuracy. Put fifty or so in a rotary tumbler for 20-30 minutes and the remains of the sprue will be virtually undetectable. Of course, they look like miniature lead golf balls when you're done, but, once again, I don't see any adverse effect on accuracy.
__________________
Sometimes the squeaky wheel gets replaced...

SASS 47015
Jbar4Ranch is offline  
Old February 24, 2008, 02:07 PM   #5
ED21
Member
 
Join Date: June 5, 2007
Location: NC
Posts: 29
If you can't live with the sprue get yourself a cast iron skillet or dutch oven. Put enough balls in to cover no more than half the bottom. Place in the bed of your truck or your trunk and drive around for a week or so. The sprue should be gone or greatly reduced. If the sprue is not gone to your liking, cut more of it off with side cutters before putting in the pan. For match shooting or where accuracy counts, weigh the balls before using.
ED21 is offline  
Old February 24, 2008, 02:34 PM   #6
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,124
All I ever do is cut the sprue with the regular sprue cutter on the mold then run a piece of rough sandpaper across the ball to remove the little nub remaining. Seems to work OK.

Jim
__________________
Jim K
James K is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:22 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07311 seconds with 9 queries