The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Reply
 
Thread Tools
Old December 16, 2007, 10:10 PM   #1
poko
Member
 
Join Date: December 16, 2007
Posts: 22
.45 Colt SAA Firing Pin

Greetings:

New poster here. I have a question regarding my new 3rd gen. Colt SAA. If I need to seek the answer in another forum please direct me. I have a 2nd gen. Colt SAA and the firing pin on the hammer is fixed tight...doesn't move. On my newly acquired 3rd gen. Colt SAA the "pin" moves around a bit. Was this an upgrade specific to 3rd gen. SAA's or is this a defect? I shot the pistol todey and it shoots just fine.

Thanks,

Chuck
poko is offline  
Old December 17, 2007, 04:05 AM   #2
Rusty.it
Member
 
Join Date: May 29, 2007
Posts: 50
it's just an easy way to get good alignment of the pin in his hole!
It's drive in by the conical part of it
Don't worry, my SAA by Pietta work in the same way and work well!
ciao
Rusty
Rusty.it is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:02 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06242 seconds with 7 queries