The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Gear and Accessories

Reply
 
Thread Tools
Old December 1, 2007, 06:39 PM   #1
OSUCowboy
Member
 
Join Date: November 29, 2007
Location: OKC
Posts: 43
.22 LR conversion kits for Glock

I recently purchased a .22 LR conversion kit from American Arms (very reputable) for my Glock 30. I went out to shoot it, and about 1 every 3 rounds would fail to cycle. Upon closer examination, I found that my trigger was not resetting after the shot, even though the slide cycled and chambered a fresh round (I never had a failure to fire any round when the trigger was reset). I tested my gun with an empty chamber by pulling the trigger and cycling the slide by hand. It was impossible to cycle the slide without resetting the trigger, even if I held the trigger down while cycling the slide. Anybody had this same experience, or have any tips for what might be wrong?
OSUCowboy is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:48 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.04877 seconds with 7 queries