The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old November 9, 2007, 03:43 PM   #1
Nasty-G
Member
 
Join Date: September 20, 2007
Posts: 28
38 case prep.

Any reason to bell the case mouth on 38 Spec. when reloading beveled base bullets ? Thanks.
Nasty-G is offline  
Old November 9, 2007, 04:37 PM   #2
Jim Watson
Senior Member
 
Join Date: October 25, 2001
Location: Alabama
Posts: 11,000
Yes, an unflared case mouth will still scrape up lead as it comes above the bevel base. That bevel is just to get the bullet started in the case easily and does not substitute for a bell.
Jim Watson is offline  
Old November 9, 2007, 05:17 PM   #3
ArizonaRick
Member
 
Join Date: November 1, 2006
Location: Southern Missouri - Ozarks
Posts: 89
Bell at the mouth

Most reloading manuals will give you a great over-view of this process. For me, when loading cast lead bullets, I bell the mouth wide enough to not cause lead shaving during the seating process. For jacketed bullets, I bell the mouth just enough for the bullet to sit on the case mouth (without falling off) before going into the seating die. I use Dillon 550 & Square Deal equipment. Good luck - RKS
ArizonaRick is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:06 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06478 seconds with 7 queries