The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old September 7, 2007, 11:41 PM   #1
w_houle
Senior Member
 
Join Date: March 29, 2007
Location: Junction City, KS
Posts: 1,389
CZ-52 magazine catch...

... lacks a thumb catch, and that irks me more than a hair. Is there anyone that makes a replacement magazine catch with one on it, or could I have one brazed or silver soldered onto it?
w_houle is offline  
Old November 3, 2007, 05:28 PM   #2
william235
Junior Member
 
Join Date: October 29, 2007
Location: South Florida
Posts: 2
Got One at FAC Supply

I owned a CZ52 for a while and was bothered by the lack of a useable slide release. I found one here:

http://www.facsupplystore.com/prodde...sp?prod=ZA1171

That being said, it only lasted a few weeks and then the extended part snapped off. Don't know whether it was bad design or bad luck. It looked like it should have worked fine, but did not last. It also required some mods to the grips requiring a little Dremel work. Might be worth a look. BTW, when it snapped off it just functioned like the original and did not affect the operation of the gun.
william235 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:43 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05900 seconds with 7 queries