The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old April 28, 2007, 06:55 PM   #1
Huntzalittle
Member
 
Join Date: January 10, 2007
Location: Michigan
Posts: 99
30-338 Trim

Can somebody give me the overall trim length for 30-338 winchester brass?
Thanks!
Huntzalittle is offline  
Old April 28, 2007, 09:11 PM   #2
Trapper L
Senior Member
 
Join Date: November 20, 2006
Location: South Texas
Posts: 804
For all of my 30-338s, I trim to 2.490 which is .010 less than the max length of 2.500. Hope yours shoots as good as the ones I have. I'm running the Speer TNTs out of my 40X at a little over 3600'ps and it will disassemble a coyote. I don't push the Sakos that I have in this caliber that hard but the Remmy just keeps tickin' and a kickin'.
Trapper L is offline  
Old April 28, 2007, 09:16 PM   #3
Huntzalittle
Member
 
Join Date: January 10, 2007
Location: Michigan
Posts: 99
Thanks!

Thanks Trapper for that reply!
Huntzalittle is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:00 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06149 seconds with 7 queries