The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old April 11, 2007, 06:49 PM   #1
dale taylor
Member
 
Join Date: February 10, 2005
Location: florida
Posts: 97
Stevens 512

Does anyone have experience with this old gun? ?Savage? daleltaylor@att.net
dale taylor is offline  
Old April 11, 2007, 09:04 PM   #2
ebutler462
Senior Member
 
Join Date: March 16, 2007
Location: NC
Posts: 437
Describe this gun, please. The only reference I have found on a model 512 is a Marlin Bolt Action. Are you sure that it is a Stevens? I have found a test that was done with the Marlin 512 by "Gun Tests" magazine.

If it says Savage or Stevens on the barrel, I can't help you, as I have no such listing.
ebutler462 is offline  
Old April 11, 2007, 09:41 PM   #3
dale taylor
Member
 
Join Date: February 10, 2005
Location: florida
Posts: 97
Gun is pump with squarish receiver used as riot pump in WW2 by Army and Marines.
dale taylor is offline  
Old April 11, 2007, 09:43 PM   #4
MDman
Senior Member
 
Join Date: March 19, 2007
Location: maryland
Posts: 535
i belive this is it http://savagearms.com/st_shotgun.htm
MDman is offline  
Old April 11, 2007, 10:11 PM   #5
ebutler462
Senior Member
 
Join Date: March 16, 2007
Location: NC
Posts: 437
His post states that he has an old pump gun. The Turkish model is relatively new O/U. I can't reference this gun.

BUT, we tried.
ebutler462 is offline  
Old April 12, 2007, 06:59 PM   #6
ZedD
Junior Member
 
Join Date: September 24, 2006
Posts: 7
Squarish reciever, pre war pump? Could that be some variant of the Stevens 520? The one that used the Browning design.
ZedD is offline  
Old April 12, 2007, 07:47 PM   #7
dale taylor
Member
 
Join Date: February 10, 2005
Location: florida
Posts: 97
That sound like it. Thank you!!! Dale
dale taylor is offline  
Old April 12, 2007, 07:50 PM   #8
ebutler462
Senior Member
 
Join Date: March 16, 2007
Location: NC
Posts: 437
I can find no reference to this gun. From the description I am guessing it is a Browning clone.
ebutler462 is offline  
Old April 12, 2007, 08:28 PM   #9
ebutler462
Senior Member
 
Join Date: March 16, 2007
Location: NC
Posts: 437
Found this on another forum. It is a Browning design pump.

There are some small points to be aware of with these older 520/620 designs. There is normal operation of the hook that interrupts the hammer engagement to the trigger, up until the bolt is closed and the action slide is fully forward and locks. That also frees the hook holding the hammer, just like on older Ithaca 37's, etc., but the hook CANNOT re-engage the hammer if you operate the slide release to check the chamber, for example.

If you do not then also pump the bolt sufficiently to the rear to re-actuate the hammer-cock part of the sequence, the hook is not engaged to prevent unintended hammer fall if you happen to pull the trigger.

If that happens when a shell is chambered, some wear on other parts may allow that shell to fire without the lock-up being fully engaged, with damage to the locking hole in the frame being a definite possibility. When the bolt slide (part just below the bolt body) is back a certain amount, it's rear edge now functions as a hammer block, so there will not be a strike against the tail of the firing pin if the trigger is pulled.

Try these tests with an empty gun to verify that yours operates in such a manner.

Pump the gun closed, operate the slide release, pump the bolt back enough to see the locking block start to drop down out of the square notch in the top of the frame, now pull the trigger. Click.

This cannot happen with the more modern designs of such new guns as the Winchester Model 12, Remington 870's, Mossberg 500's, and others, as long as the parts fit is still good.

These 520/620 style guns will be OK for use as long as the shooter recognizes the proper sequence of operations that will allow safe use, and you might consider having that gun properly disassembled and cleaned of the 50 year old varnish that used to be oil.

This info came from kirbythegunsmith.
ebutler462 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:43 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07424 seconds with 7 queries