The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old April 11, 2007, 07:06 AM   #1
anand
Senior Member
 
Join Date: December 11, 1999
Posts: 276
What powder does S&B use for its 7.62x25 Tokarev?

Greetings fellow members,
Been trying to figure out what powder S&B uses for its 7.62x25 Tokarev cartridges. As far as I can tell from the velocity figures I have been getting from my own research and comparing these to the figures in the LEE reloading manual, I am guessing its identical to, or is infact Accurate #5.
The figures are close enough to about +/- 18 fps. I assume this variance may be due to factors other than powder charge itself, such as bullet seating depth, crimp etc.Can anyone verify this or give more information.
Thanks abunch,
Anand
anand is offline  
Old April 11, 2007, 09:16 AM   #2
Mal H
Staff
 
Join Date: March 20, 1999
Location: Somewhere in the woods of Northern Virginia
Posts: 14,523
Rarely if ever does a major ammunition manufacturer use a "canister" powder in its loads. Canister powder being powder that the average consumer can buy off the shelf. The companies most often use a proprietary blend of 2 or more powders.

Even if they did use a commonly available powder, anyone, without the proper analysis equipment, would be foolhardy to make an assumption as to its make up and burn rate. In other words, don't guess. Use readily available information in various reloading manuals instead.
Mal H is offline  
Old April 11, 2007, 09:32 AM   #3
Smokey Joe
Senior Member
 
Join Date: July 14, 2001
Location: State of Confusion
Posts: 2,064
Duplicating factory loads

Anand--I was going to jump on this but Mal H beat me to it. Second what he said.

I'll add that if you are loading a similar bullet to the commercial load, you get similar velocities--and +/- 18 fps is as similar as you'll ever get--and a similar POI out of your firearm, you have essentially duplicated the factory ammo, even without duplicating the powder they use.

But in any case, don't go over the max load listed in published load manuals from reputable sources. That way lies trouble.
__________________
God Bless America

--Smokey Joe

Last edited by Smokey Joe; April 11, 2007 at 09:36 AM. Reason: The usual--had another thought.
Smokey Joe is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:23 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05962 seconds with 7 queries