The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old March 11, 2007, 02:00 AM   #1
studioandolina
Junior Member
 
Join Date: March 11, 2007
Posts: 1
Lookin for >220 swift brass........

Hello,

I am a new reloader and I am looking for anyone that has any 220 swift brass. I can buy or perhaps trade for this if you have any. I am also looking for loads and any advice you can give.


Thanks a whole lot,

GA
studioandolina is offline  
Old March 11, 2007, 01:15 PM   #2
Trapper L
Senior Member
 
Join Date: November 20, 2006
Location: South Texas
Posts: 804
Take your pick:
http://www.midwayusa.com/ebrowse.exe...*670***9013***

I buy a lot of goodies from Midway and have never has a bad experience. Check out bullet prices too. I wouldn't suggest primers or powders via the internet unless you buy a lot. There is a hazmat fee that runs the cost up on shipping.
Trapper L is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:24 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05489 seconds with 7 queries