The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old January 22, 2007, 05:37 PM   #1
MikeRussell
Senior Member
 
Join Date: December 29, 2006
Location: Carencro, LA
Posts: 296
short OAL?

Hey guys, I'm kind of new to reloading, so bear with me. I made up a few of my first test rounds (have yet to fire them) on a couple of different set ups. I was kind of questioning the FMJ (actually plated) 230gr load in the Hodgdon manual. It was for a OAL of 1.200, with somewhere in the range of low 4s to low 5s in grains (I loaded 4.8) of W231, Winchester LP primers. Now, I've seen a lot of people and other avenues recommending higher powder charges and a longer OAL (in the 1.225 - 1.25 range). Does this load seem a bit short for the powder charge or am I just being overly cautious? It looks really short when loaded too.

My other load I'm testing is a 200gr LRNFP over 4.7gr of W231 w/ OAL of 1.225 (middle of the road loading according to the Hodgdon manual, there was no LRNFP listed, so I used the data for a LSWC). Anything seem out of the ordinary on that one to anyone?
__________________
Mike Russell
MikeRussell is offline  
Old January 22, 2007, 05:47 PM   #2
JohnLizCas
Senior Member
 
Join Date: November 21, 2004
Location: NJ
Posts: 162
short OAL

Try looking at other reloading manuals or go online to the powder manufacturer's reloading sections. OALs differ according to methods used in testing. If you're not sure check with other sources. Don't take chances with your hands and eyes not being the way God created them.
If the rounds turn out to be too short, use a bullet puller to disassemble the rounds and reload them to longer specs
__________________
For those who have had to fight for it, life holds a special meaning that the protected will never know.
JohnLizCas is offline  
Old January 22, 2007, 05:50 PM   #3
okiefarmer
Senior Member
 
Join Date: February 20, 2006
Location: Oklahoma
Posts: 381
Mike,

You don't state as such, but I am assuming you are loading the ACP round with that area of OAL. My manual, the LEE, indicates a minumum 1.19 OAL, with 231 powder (4.8 - 5.1 gr) with a 230 JRN. Anything over that is not going to hurt as long as it fits in the mag. Less OAL would possibly be a compressed load and that could cause problems. Seat it out as far as you like, or wherever it feeds best in your toy.

My two pesos,

Okie out
okiefarmer is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:12 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06153 seconds with 7 queries