The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old October 10, 2006, 11:35 AM   #1
saands
Senior Member
 
Join Date: November 14, 1999
Posts: 1,551
Star BM - Firing pin removal???

I am in the process of refinishing a Star BM and I would like to remove the firing pin. Removing the rear sight reveals the large head of what appears to be the firing pin's retaining pin. The smaller end of that retaining pin appears to be exposed on the under side of the slide. Sooooo ... it would seem logical that a little tap with a punch on the small end of the retaining pin would take care of things, but the retaining pin doesn't move, even with a reasonably firm tap. I just wanted to know if this just needs more force, or if there is a trick (ie. the firing pin needs to be in a certain position, or some such thing).

TIA,

Saands
saands is offline  
Old October 10, 2006, 01:03 PM   #2
cntryboy1289
Senior Member
 
Join Date: July 19, 2004
Location: Ms
Posts: 1,160
info

It most likely just needs a good firm couple of taps to get it moving along. Depending on the amount of dried oil and how long it has been in the gun can both cause it to be hard to come out. Use a good punch and a firm hand to get it started and once it is loose, it should just tap out for you.
cntryboy1289 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:12 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05876 seconds with 7 queries