The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old October 8, 2006, 09:57 PM   #1
jwp6114
Junior Member
 
Join Date: September 7, 2006
Location: johnstowm PA for now
Posts: 7
Who All Loads 50ae?

What are some of your favorite loads.
jwp6114 is offline  
Old October 9, 2006, 11:17 AM   #2
Jbar4Ranch
Senior Member
 
Join Date: May 19, 1999
Location: Near Helena, Montana
Posts: 1,543
Desert Eagle: 32.5 grains H110 or W296, Speer 325 Uni-Cor hollow point, magnum primer.
34.5 grains H110 or W296, Speer or IMI 300 grain soft point or hollow point, magnum primer.
23.5 grains AA#9, Speer 325 grain Uni-Cor hollow point, magnum primer. This one is a little easier on the hands & wrist, cycles the action reliably, and the empties don't bounce off your forehead as is common with the above full power H110/W296 loads.

Freedom Arms M555: 30.0 grains H110 or W296, cast 350 grain SWC w/gas check, magnum primer. I've never felt the need to experiment any further, as this load will often put all five into three inches, or a tad less, at 100 yards from a good rest with a 2x Leupold scope, and very, very seldom breaks the four inch mark.
__________________
Sometimes the squeaky wheel gets replaced...

SASS 47015
Jbar4Ranch is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:09 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06737 seconds with 7 queries