|
September 27, 2006, 02:57 PM
|
#1 |
|
Junior member
Join Date: December 15, 2005
Posts: 558
|
Handgun Reblueing?
i took my s&w model 27 out last night and spotted a small bit of rust on the side plate
 ..... since there are a couple of dings in the finish from the time i dropped it anyway  . i was wondering who had the best deals on refinishing my baby. needs the dings takin out and the blueing redone i guess... i had thought about sending to smith&wesson for a factory job but i need some input on some smiths too. outside of the dings in the barrel and the cylinder and the rust spot about the size of a pin head the thing is in great shape for a 1968 vintage revolver.... ideas? LIFE IS SHORT................................................. |
|
|
September 27, 2006, 07:45 PM
|
#2 |
|
Staff
Join Date: March 17, 1999
Posts: 16,608
|
On a Model 27, I would not trust anyone but S&W.
Jim
__________________
Jim K |
|
|
|
September 27, 2006, 08:08 PM
|
#3 |
|
Senior Member
Join Date: February 26, 2006
Location: grafton, ma
Posts: 225
|
doug turnbill
|
|
|
|
September 27, 2006, 08:33 PM
|
#4 |
|
Senior Member
Join Date: May 4, 2001
Posts: 6,589
|
S&W will have the best combination of quality, price, and turnaround.
Plus a genuine factory re-finish is less damaging to the value than a non-factory re-finish. Plus, while S&W has it, they will check it over for you. |
|
|
|
September 27, 2006, 10:50 PM
|
#5 |
|
Junior member
Join Date: December 15, 2005
Posts: 558
|
YEP D-FERRIS..... i'd have the techs at s&w look it over while was there for sure... i should go over to the smith&wesson website to check on getting it done.... any tips on how to keep a blued gun from rusting ?? i did think it was covered good with rem oil anough to keep it from doing that anyway.
LIFE IS SHORT......... |
|
|
|
September 27, 2006, 11:13 PM
|
#6 |
|
Junior member
Join Date: November 12, 2004
Posts: 449
|
|
|
|
|
September 29, 2006, 12:07 PM
|
#7 |
|
Junior member
Join Date: December 15, 2005
Posts: 558
|
after seeing those reports on the s&w forum i'm really guessing what to do now....... you'd think they might have some really good craftsmen there to work on those old treasures but i guess not......
LIFE IS SHORT........ |
|
|
|
September 29, 2006, 02:20 PM
|
#8 |
|
Senior Member
Join Date: April 7, 2006
Posts: 6,479
|
Sounds like your gun is not in bad shape at all. If so, even a factory refinish would severely devalue it.
Bill |
|
|
 |
| Thread Tools | |
|
|
