The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old September 22, 2006, 11:31 PM   #1
vicvic
Member
 
Join Date: October 25, 2004
Posts: 83
ak trigger group removal

i am using a punch to try to knock out the pin but it doesnt budge. is there something im missing
vicvic is offline  
Old September 23, 2006, 06:58 AM   #2
sleeping dog
Senior Member
 
Join Date: March 2, 2000
Location: MI
Posts: 536
It's been a while since I dismantled my SAR-1, but I seem to remember a "J-spring" or something inside, fitting into a slot in a pin. That has to be removed first. I don't remember which pin(s) it holds.

Then, I think one end of the pin is bigger than the other. You have to push on the skinnier end, drive it out the "big hole" side.

Google "AK Forum" and you might find some good instructions.

Regards.
sleeping dog is offline  
Old September 23, 2006, 03:02 PM   #3
Dfariswheel
Senior Member
 
Join Date: May 4, 2001
Posts: 6,843
Here's a site with full disassembly, and diagrams showing the "Shepard's Hook" trigger assembly retaining wire:
http://www.ak-47.net/ak47/comp/comp.html

Here's an ever better site:
http://www.gunsnet.net/linx310/fcgremoval.htm
NOTE: this is for the Rumanian rifles, and on these rifles, the hook is remove FORWARD. MOST rifles have to be removed to the REAR.

This wire varies somewhat, but basically, it's a wire "hook" on the LEFT side of the receiver that wraps around the trigger pin, then goes forward and UNDER the hammer pin.
The pins have grooves which the wire interlocks with holding the pins in the receiver.

IN GENERAL (it varies) you use a punch or screwdriver to push the forward "leg" of the wire DOWN from the HAMMER pin, then slide the hammer pin out.

(Note: the pins have a groove the wire locks into. The groove tends to get hung up on the thin receiver, and unless you get it aligned properly, the pin will not come out.
DO NOT hammer or try to drive the pins out, you'll RUIN the receiver. They AREN'T "stuck" the groove is catching on the receiver sides).

After pressing the wire down and getting the hammer pin out, push BACK on the FRONT leg of the pin to get it to unsnap from the trigger pin, then remove it from the receiver.

Depending on the version of the wire, you may be able to push the wire back and remove it before the hammer pin is removed.
Dfariswheel is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:24 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05663 seconds with 7 queries