The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old October 26, 2000, 10:45 AM   #1
westvirginia
Member
 
Join Date: March 10, 2000
Location: Atlanta
Posts: 23
I just received some new Remington cases and before sizing, I decided to check case length. From case to case the length is uniform, but all are about .003 from max length. Is that normal, or should they be shorter fresh from the factory? Also, do I need to trim before using or will they still be OK once sized? I'm no reloading pro, but I have had some success with .38, .45ACP and some .30-30 loads. I've just never loaded this caliber before and want to be safe w/my 1895. I appreciate any help anyone can give me.

------------------
Is life so dear, or peace so sweet, to be purchased at the price of chains and slavery?
westvirginia is offline  
Old October 26, 2000, 11:49 AM   #2
Mike Irwin
Staff
 
Join Date: April 13, 2000
Location: Northern Virginia
Posts: 36,327
I think you're going to find that your .45-70 cases won't lengthen much, if at all, and they may even shrink a little bit.

Low pressure rounds like the .45-70 don't tend to lengthen much.

You may want to give them an initial trim just to make certain that they are all the same length, and then forget about it for a couple of firings.

------------------
Smith & Wesson is dead to me.

If you want a Smith & Wesson, buy USED!
Mike Irwin is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:55 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05401 seconds with 7 queries