The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old September 2, 2000, 10:50 PM   #1
ronploude
Junior Member
 
Join Date: August 19, 2000
Location: Miami, Florida, USA
Posts: 4
Prior to moving to South Florida 20 years ago, I was an active skeet shooter. A change of friends and two kids later, I find myself with four pounds of 452AA powder sitting in my garage un-opened. I now reload for 44 mag and 45LC and would like to use up this powder for light target loads.

None of the Winchester reloading books that I've accumulated over the years list pistol loads for this powder. Winchester powder's technical support was not familiar with the powder and could not give me any guidance. A few months ago, I read an article by E.D. Harris that claims that 452AA is the same powder at Hodgdon's Trap 100. Checking old Hodgdon reloading books, I found light loads using Trap 100 for both the 44 mag and the 45LC.

Has any one in this forum used either of these powders, 452AA or Trap 100, for pistol loads? These powders go back a few years so you may not remember anything about the reloads' characteristics but, if you can, I would welcome your sharing them.
ronploude is offline  
Old September 3, 2000, 06:32 AM   #2
Ken in Iowa
Member
 
Join Date: November 18, 1999
Location: Montezuma, IA
Posts: 70
Try looking under 45ACP in the older manuals. It was the "best" powder for Bullseye Match loads in that caliber.
Might be a bit fast for .44 Mag and .45 Colt size cases. Would be great in .44 Special.

------------------
Ken in Iowa is offline  
Old September 4, 2000, 10:48 PM   #3
dundee
Senior Member
 
Join Date: December 6, 1998
Location: mytown,mi,usa
Posts: 162
10+ years ago WW 452 was the hot powder for 45 acp loads in IPSC competition. In light to medium loads for the 45 acp it is quite good. In 44 mag cases it will probably be only a light torget type load.
Try the IPSC web site and see if they can give your exact loads.
dundee is offline  
Old September 5, 2000, 07:57 PM   #4
ronploude
Junior Member
 
Join Date: August 19, 2000
Location: Miami, Florida, USA
Posts: 4
Ken and Dundee, thanks for the input. I pulled a 1985 Winchester load book out of my book case after reading your responses and it did list 452AA loads for 45ACP. The two loads listed are for a 185 gr. F.M.C. (full metal case) bullet. Also listed using this powder are a few loads for the 38 special. Although, I had looked in this manual before, I must have looked only at the 44mag and 45LC load listings. The fact that light loads of 4.0gr and 4.5gr of 452AA are listed gives me some encouragement that I can ultimately develop light target loads for the 44mag and the 45LC. I am also encouraged that E.D. Harris stated in an article that 452AA and Trap 100 are the same powder. Old Hodgdon load books have a number of load listings for that powder in both the 44mag and the 45LC.

I'm confident enough at this point to experiment with it using Trap 100 load recommendations. The one factor that held me back before was a concern for detenation from using a powder for light pistol loads that its manufacturer had designed specifically for shotgun usage. Thank you both for taking the time to reply.
ronploude is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:13 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06561 seconds with 7 queries