The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old August 15, 2000, 01:19 PM   #1
Dave P
Senior Member
 
Join Date: August 16, 1999
Location: North Florida
Posts: 1,133
Has anybody had any success with a high speed, light bullets? (Success means that the rifle cycles consistantly.)

Looks like 110 gr with 45 gr of Acc 2520 is an acceptable mix, but will the gun like it?

Thanks
Dave
Dave P is offline  
Old August 15, 2000, 03:32 PM   #2
Bottom Gun
Senior Member
 
Join Date: October 13, 1998
Location: Elgin, Arizona
Posts: 871
My Garand likes the Speer 125TNT HP with 53.0 gr IMR4064.
This is a VERY explosive bullet.
Bottom Gun is offline  
Old August 15, 2000, 09:40 PM   #3
Art Eatman
Staff Lead
 
Join Date: November 13, 1998
Location: Terlingua, TX, USA
Posts: 22,540
BottomGun, that sounds like a bit hot for the Garand. It's possibly hard on the operating rod.

The load itself is okay; I've been using 52.5 grains of 4064 behind a 150-grain bullet for 50 years, now.

Everything I've read, and a lot of knowledgeable folks on TFL, talk of using a bit faster burning powder, and holding chamber pressures to around 47,000 psi (design pressure). I'd guesstimate your load at around 49,000 to 50,000 psi.

The Garand is designed for 2,000 psi at the gas port. Over that, it's hard on the operating rod. Slower powders than 4895 tend to maybe be noticeably higher at the gas port, so I've read.

I'd guess that the M1A is similarly designed, insofar as pressure (?). I'd use a 110-grain bullet, and with 4895, some 200 ft/sec under whatever the loading manual says is max. Dunno; FWIW, the .308 factory loads were shown as having a chamber pressure of 53,000 psi in the early days of that cartridge.

Hope this helps, Art

[This message has been edited by Art Eatman (edited August 15, 2000).]
Art Eatman is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:57 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06464 seconds with 7 queries