The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old July 2, 2000, 04:23 PM   #1
4V50 Gary
Staff
 
Join Date: November 2, 1998
Location: Colorado
Posts: 16,594
I a have Parker Hale .577 Minie Ball mould for which I need handles. Tried a Lyman larger and found it to be too short. The pins for the block(s) is set about 23 mm (center of pin) or 7/8" from the edge. TIA
4V50 Gary is offline  
Old July 5, 2000, 11:07 PM   #2
4V50 Gary
Staff
 
Join Date: November 2, 1998
Location: Colorado
Posts: 16,594
BTT. You know, I can drill some handles to fit, but since I have to buy them, it's easier to buy one that fits.
4V50 Gary is offline  
Old July 10, 2000, 01:50 AM   #3
4V50 Gary
Staff
 
Join Date: November 2, 1998
Location: Colorado
Posts: 16,594
Been told that RCBS made the molds for Parker Hale. Can somebody please look at their RCBS mold handles and let me know what size to order?
4V50 Gary is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:04 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06053 seconds with 7 queries