The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old July 7, 2006, 08:04 PM   #1
choover
Senior Member
 
Join Date: March 27, 2006
Posts: 172
Am I right about 357 sig

If i were to reload this, I just need 9mm bullets for the brass .355? I was looking at that and that would make my sig ALOT cheaper to feed :P
choover is offline  
Old July 7, 2006, 10:16 PM   #2
rangermonroe
Senior Member
 
Join Date: January 27, 2005
Location: savannah
Posts: 758
Yes, to a point....

Not all 9mm bullets will crimp tightly enough.
These will not work http://www.midwayusa.com/eproductpag...lastID=7620061
Round nose bullets seem to get pushed back on me, but truncated cone varieties will stay firm.

IMHO, any straight sided 9mm bullet will work. I have had the best luck with Hornady XTPs.

I resize .40s to make 357SIG. The neck is a bout 10-15 thousands shorter, but it stretches with firings. Also 40 brass will have a few ftf, until fire formed, so I use it for training ammo.

Yes it does make it a lot cheaper.

Every body leaves once fired .40 at the range.

Last edited by rangermonroe; July 7, 2006 at 11:25 PM.
rangermonroe is offline  
Old July 8, 2006, 01:08 AM   #3
griz
Senior Member
 
Join Date: July 31, 2000
Location: Middle Peninsula, VA
Posts: 1,433
Just as an elaboration of what he said, The short length of the Sig requires a bullet with a short nose. If you get a long tapered nose like some 125 grain 9mm bullets have, then when seated to the correct OAL the gently sloping part of the nose is located at the neck of the case. Easy solution, use short stubby bullets.
griz is offline  
Old July 8, 2006, 08:35 AM   #4
JNewell
Senior Member
 
Join Date: March 12, 2000
Posts: 1,092
Further elaboration - if you get bullet set-back, which is very easy to have happen with the .357 SIG case, you are likely to see pressures spike upwards.
JNewell is offline  
Old July 10, 2006, 08:11 PM   #5
skeet47
Member
 
Join Date: November 2, 2005
Posts: 50
357 sig

I use Berry's plated 38 bullets.They have a flat nose and are a little larger in diameter.I use a Lee factory crimp tool to put everything as it should be and all has always gone well with this combination.
skeet47 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:40 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06875 seconds with 7 queries