The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old April 25, 2000, 04:13 PM   #1
Tomas
Senior Member
 
Join Date: May 9, 1999
Location: Blue State
Posts: 384
I'm reloading .308 for my M1A.

I was using 50.1 gr of 760 with OAL of 2.70, with a Hornady 150gr FMJBT. I was also using a light crimp. A couple times the action didn't cycle, what I can only attribute to pressures to low to cycle the action, so I decided to go to a faster powder.

I'm trying VARGET with the same Hornady bullet and Hodgden gives 2.80 as OAL. I notice that the cannelure is still completely out of the case at 2.8 OAL. Should I seat the bullet deeper anyway, and crimp, or just ignore this and crimp above the cannelure at 2.8 AOL? I'm concerned if I seat too deep the pressures may get to high, but it seems like I should be seating the bullet so the cannelure engages the brass. I'm starting at 43.0 grains and working up. Also, I keep reading that in rifle that the closer the bullet is to the rifling the better. I really don't know what to do.

I've only been doing rifle reloading for a few months, so please be specific in your suggestions.

Thanks a lot for your help.

Tom
Tomas is offline  
Old April 25, 2000, 08:41 PM   #2
AL@PA
Member
 
Join Date: March 22, 2000
Posts: 24
I've been using the same 150gr bullet with Varget powder, I seat the bullet @ 2.780 and
ignore the cannelure.....works fine. By the
way, the load I use in my M1A is 41.2gr works
well out to 500 yards. Have fun, read the wind.
AL@PA is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:58 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05523 seconds with 7 queries