The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old April 13, 2000, 11:25 AM   #1
goat
Senior Member
 
Join Date: February 14, 2000
Posts: 161
I have an rcbs ammomaster.It is a decent piece of gear except for the seat and crimp process.RCBS suggests that the two processes be done in the same station.This is not the correct way to do it.No matter how I set the dies I can not stop "pushing lead"or "shaving copper"I know the dies are set right.But I get either to much or not enough.I purchased another crimp die and now I do the crimp in a separate station.It is difficult but can be done.Does anyone else have this problem?
goat is offline  
Old April 13, 2000, 04:36 PM   #2
The specialist
Senior Member
 
Join Date: January 10, 2000
Location: boston,MA,USA
Posts: 237
Goat I have the RCBS dies and my die does both no problem. The way I adjusted it was seat a dummy round and adjust for the crimp first. Once the crimp was adjusted right then I adjusted the seating plug. I use the .40 s&w RCBS dies.
The specialist is offline  
Old April 14, 2000, 09:14 AM   #3
JoeHatley
Senior Member
 
Join Date: July 1, 1999
Location: Iowa
Posts: 2,135
goat,

I've been seating and crimping at the same time, using an RCBS die for over 20 years.

When ever I have a lead shaving problem, the places I look at are:

1) Make sure the inside case mouth has been chamfered. Very important with cast bullets.

2) Make sure the case mouth has been belled enough to easily start the bullet.

3) Double check the bullet diameter. Some times cast bullets run a little large, or don't get sized.

4) Verify my dies are clean inside. Lube from cast bullets and shavings can really mess thing up.

Good Luck...

Joe




------------------
Go NRA
JoeHatley is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:44 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06145 seconds with 7 queries