The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old March 26, 2000, 09:24 AM   #1
RDF
Senior Member
 
Join Date: August 9, 1999
Location: West Liberty, Ky
Posts: 131
I have a remington 700 ADL in .243 and
9 1/8" rifle twist. what,s a good round for hunting and varmiting. Right now i'm using factoy loads trying to see what shoots good.
Have used 55gr,70gr,80gr,and 100gr but not real happy with the groups. Any certain ammo i should try?

[This message has been edited by RDF (edited March 27, 2000).]
RDF is offline  
Old March 27, 2000, 08:44 AM   #2
Hakwe
Junior Member
 
Join Date: September 26, 1999
Posts: 3
I am using .243 Winchester rounds in a Tikka and have had good results with the following hand loaded round.

Projectile : Hornady 75 Grain V-Max
Powder : ADI AR-2206
Charge Weight: 34.1 Grains
Overall Lenght : 76mm plus or minus .1mm

------------------
Hakwe is offline  
Old March 27, 2000, 11:45 AM   #3
Art Eatman
Staff Lead
 
Join Date: November 13, 1998
Location: Terlingua, TX, USA
Posts: 22,576
I have long used the Sierra 85-grain HPBT for all-around shooting in my .243. I won't use it for larger deer; just in the 90 to 125-pound (field-dressed) central Texas whitetail range...

I have had very good groups from the Federal ammo that uses this bullet.

My favorite handloads are the 85 with 37.5 grains of 3031 (start at 36.0 grains and work up.) and the 60-grain Hornady with 40.0 grains of 3031 (Start at 38.0...). My groups run 3/8" to 1/2", generally.

You might check the bedding on your rifle. My opinion is that the barrel should not touch the wood of the fore-end of the stock. After I free-float a barrel by removing wood from the channel of the fore-end, I then shim with wax paper out at the tip. A 1/2" strip, folded back and forth until the thickness requires about a five-pound pull to put it in place, works well. Trim with a razor. Shoot several quick shots to heat the wax so it will stick...

Good luck, Art
Art Eatman is online now  
Old March 29, 2000, 08:52 AM   #4
k in AR
Senior Member
 
Join Date: October 12, 1999
Location: Arkansas USA
Posts: 434
I agree with the Sierra 85gr GameKing HPBT. I have had excellent results with them. I have found that this bullet works very good with several powders, my favorite is IMR 4350.

I first went to this bullet for my 243 a few years back when my wife needed some ammo & I picked up a box of Federal Permium with this Sierra bullet (they were out of the 100gr SPBT which I had been using). I couldn't believe how accurate her Weatherby was with this "little" factory load. So I bought a box of the 85gr HPBT Sierra bullets & haven't looked back.

Enjoy, k
k in AR is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:49 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06924 seconds with 9 queries