The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old March 25, 2000, 09:56 PM   #1
Senior Member
Join Date: June 6, 1999
Location: El Paso, TX
Posts: 1,019
Hi, having read alot about moly in the last week or two I desided to pick up a small aerosol can of it. It's from Brichwood/Casey and it called "Moly Lube" for those of you who have heard of it.

So, having 4 calibers, and only one that I reload for, could I put moly on a cleaning patch and run it through the barrel of my gun? Also, how long does this stuff last, I.E. how often would I have to reapply?

And is thier anything I would need to do to my barrels other than clean them out and let them dry before I apply moly?


Self improvement is a hobby of mine
Adamantium is offline  
Old March 26, 2000, 01:13 AM   #2
Join Date: July 18, 1999
Posts: 15
Your barrel must be absolutely clean of all powder & copper fouling before applying moly to it! You can apply moly to the bullets of loaded rounds; Ms Moly supplies perforated foam plastic pads for this purpose. You stand the cartridges up and slide the pad down over the case neck and then spray the bullet. go to for more info.
hclark is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 09:33 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.10168 seconds with 9 queries