The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old March 19, 2000, 10:44 PM   #1
BMiracle
Senior Member
 
Join Date: February 12, 2000
Posts: 159
I can't get my .308 to shoot good with handloads. I can shoot 1/2 to 3/4" groups at 100 yards with factory Federal ammo loaded with 150 Nosler Ballisic tips. When I have tried loading the same bullet I can only get about 1 1/2" groups. I have tried using both IMR 4320 and Varget (my personal favorites). Both powders have worked well in my previous calibers (.4" groups in .243!). The only thing that I can think of is the crimp. The Federal load has a tight crimp in a cannelure. I am not putting a tight crimp in my handloads. Do ya'll think the lack of crimp is not allowing consistent powder ignition? Any insight greatly appreciated.
BMiracle is offline  
Old March 19, 2000, 11:30 PM   #2
alan
Senior Member
 
Join Date: June 7, 1999
Posts: 3,745
BMiracle:

Whose rifle are you using, what sort of barrel, is the rifle bedded and so on. You might be experiencing load problems.

Using a well worn Model 70 standard Target Rifle, when I shot National Match Course competition, with iron sights, I used to hold 10 ring elevation at 600 yards. Lost points usually due to misrading wind.

I used 180 grain Sierra Matchking bullets, with 41-42 grains 4895 in military match brass, and seated bullets long, for slow fire.

4320 which you mentioned, might be a bit slow for .308 shooting 150 grain bullets. I'm not familiar with Varget, never used it. As for crimping, with jacketed bullets, WHY are you doing that. That could be causing your problem. I never found it necessary to crimp ammumnition for ANY 30 caliber rifle that I ever used (30-06 and 308).
alan is offline  
Old March 20, 2000, 02:06 PM   #3
Paul B.
Senior Member
 
Join Date: March 28, 1999
Location: Tucson, AZ
Posts: 2,634
BMiracle, Try W-748 or W-760. My personal preference is for the latter, but according to Olin, W-748 is the powder designed for the .308. IMR-4895, and H-4895 are supposed to be very good for target loadings in the .308, so you might want to look into those. IMR-4320 has been very mediocre in any cartridge I have tried it in, with one exception, and that is a magnum wildcat round.
Paul B.
Paul B. is offline  
Old March 20, 2000, 06:48 PM   #4
Bud Helms
Staff
 
Join Date: December 31, 1999
Location: Middle Georgia
Posts: 13,003
How close to the rifling is your bullet when cartridge is chambered?
Bud Helms is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:54 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06285 seconds with 7 queries