The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old February 12, 2000, 03:22 PM   #1
Bill in NM
Member
 
Join Date: January 21, 2000
Posts: 95
I've been reloading for several calibers for about a year now, and am doing pretty well. But I just ran into a snag. I'm working on my first loadings for the .357 mag. The bullets I'm using are Loredo brand 158gr SWCs. If I seat the bullet to the very top edge of the crimp groove, my round OAL is still 1.608, where max OAL is listed at 1.590. Actual sized case length is 1.280, well within specs. Loaded rounds do fit in the pistol with no problem, but I'm very leary of them.
HELP!
Bill
Bill in NM is offline  
Old February 12, 2000, 03:47 PM   #2
Mal H
Staff
 
Join Date: March 20, 1999
Location: Somewhere in the woods of Northern Virginia
Posts: 14,537
Frankly Bill, I wouldn't sweat it. If you crimp in the groove and they fit in the chambers with room to spare, they should be fine. It's not that unusual to go a little beyond the stated max OAL, and 2/100ths is about as little as it gets. You might question the rounds if they are shorter than they should be, because you might be lessening the case capacity.

For example, it's impossible to load the heavy bullets in .44 Magnums (300 gr. +) without going over the stated max OAL.
Mal H is offline  
Old February 12, 2000, 06:07 PM   #3
Nukem
Senior Member
 
Join Date: January 29, 2000
Posts: 709

Mal is right, don't sweat it as long as the cylinder turns freely. Out=more case capacity, in=less. This will *usually* equate to more capacity=lower pressures, less=higher.
There are plenty of situations where OAL it critical, i.e. making sure a round will feed in a magazine fed gun and some rifle loads where pushing the bullet onto the lands will cause a dangerous pressure rise are a few that come to mind.
Nukem is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:50 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05436 seconds with 7 queries