The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old May 12, 2006, 03:05 AM   #1
eegnayr@yahoo.com
Member
 
Join Date: March 11, 2006
Posts: 30
9mm reloading question

Would not enough gun power cause stove pipes and failure to eject? Also what other factors might cause failure to eject and stove pipes?
eegnayr@yahoo.com is offline  
Old May 12, 2006, 04:26 AM   #2
Seto_Muuvari
Junior Member
 
Join Date: May 7, 2006
Posts: 9
Now I'm no expert on this matter, but yes, Too little powder will make it stove pipe and not eject. I ran into the same problem when I was loading my 9mm's for a light recoil load. I found that just enough powder to make the slide open and cycle was enough for me.

Other problems I've seen are heavier recoil springs, broken ejectors and all sorts of problems that can make life miserable.

Someone else ought to know more, but that's just my two cents.
----------------------------------------------------------------------
"The greatest crime in the world is to own a firearm and never use it, unless that firearm is for safety. Then lets hope you never have to."
Seto_Muuvari is offline  
Old May 12, 2006, 06:15 AM   #3
English Bob
Junior Member
 
Join Date: March 9, 2006
Location: Arizona
Posts: 11
A powder that is too fast will cause it too.

I experienced those problems once when experimenting with AA#2 for a Glock 17. My loading manual warned that AA#2 might be too fast for some "high performance" 9mm's, so I wasn't surprised when it happened.

I also tried Bullseye. Starting charges of it would cycle the action properly.

For standard power loads in the 9mm, a medium burn rate powder is best. My favorite is Power Pistol.
English Bob is offline  
Old May 12, 2006, 08:40 AM   #4
Leftoverdj
Senior Member
 
Join Date: October 15, 2004
Posts: 934
Dirty, rough, or unlubricated gun can cause stovepipes. So can the use of very light bullets.
Leftoverdj is offline  
Old May 22, 2006, 12:45 PM   #5
silicon wolverine
Senior Member
 
Join Date: April 28, 2006
Location: South dakota
Posts: 674
THe best load i came up with for a glock 17 anyway is 6.2 gr of blue dot with a magnum pistol primer and a 115gr bullet of your choosing. Ive shot it with HPs, FMJs lead round nose and flat point and it works just as well in all of them.

SW
silicon wolverine is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:45 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07206 seconds with 7 queries