The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old December 23, 1999, 07:29 AM   #1
JHS
Senior Member
 
Join Date: November 30, 1998
Location: Goodwell,Ok.
Posts: 505
I was given some 160g TMJ and I don't have the info. for 160g ,using unique powder in the .40. I have two books that have 150,155,165, and 170 data, I could guess. some were around 7g's of unique?
JHS is offline  
Old December 23, 1999, 02:21 PM   #2
Paul B.
Senior Member
 
Join Date: March 28, 1999
Location: Tucson, AZ
Posts: 2,703
JHS. Use the data for the 165 gr. bullet. 5 gr. less bullet weight won't affect anything at all.
Paul B.
Paul B. is offline  
Old December 23, 1999, 03:38 PM   #3
Mal H
Staff
 
Join Date: March 20, 1999
Location: Somewhere in the woods of Northern Virginia
Posts: 14,564
... with the caveat that you should be comparing like for like as far as the bullets go. TMJ usually implies a plated lead bullet (e.g., Rainier), not a copper jacketed one. So be sure you use the data for the right type. 7 gr. of Unique sounds like too much for a jacketed bullet and is definitely too much for a plated bullet. If your into guessing, you should guess on the low or starting load side.
Mal H is offline  
Old December 24, 1999, 12:27 PM   #4
TheOtherMikey
Senior Member
 
Join Date: October 16, 1999
Location: Surprise, Arizona, USA
Posts: 171
The rule-of-thumb I was told by an experienced loader was to use the powder load data midway between lead and FMJ of same bullet weights for the copper plated bullets like Raniers and Berrys. Regards, Mikey
TheOtherMikey is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:31 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06183 seconds with 7 queries