The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old December 2, 1999, 11:18 PM   #1
TGS
Senior Member
 
Join Date: November 19, 1999
Location: Woodbury TN
Posts: 138
After 100 rounds of 300 gr and 260 gr factories (Hornady).
The brass was very tight in the chambers and when examined i have found them .006 - .008 out of square (O.D. to Rim). All the same and .0015 out of round. Ive noticed the cylinders have a tell tale out of round condition when viewing visually.
Is this condition dangerous, Im really reluctant to re-load this brass. Possibly the chamber diameters are not square to the cylinder face? Doesnt look like a condition I want to overlook or under estimate. The initial accuracy was pretty good. Under 1" at 33yds, but the emties shore look like there taking a toll first time thru. Whats going on?
TGS is offline  
Old December 7, 1999, 05:12 PM   #2
Paul B.
Senior Member
 
Join Date: March 28, 1999
Location: Tucson, AZ
Posts: 2,703
TGS. You did not say what you shot them in.I would think, from what I have seen, that any .454 Casull from Freedom Arms would be chambered to better tolerences than what you said.
Difficult extraction could be due to too hot ammo. This sometimes comes from the factories. I once had a box of .44 Magnums from one company that was so hot, I had to pound on the extractor rod with a piece of 2x4.
You also gave the impression that the brass had stretched some. While I have never had that problem with my .44's, the .454 is loades to a much higher pressure. This may be the cause of the stretching.
I would say that if you full length resize, and then trim your brass, it should be all right for reloading. The trimming is necessary so as to get an even crimp.
If you are really worried about your out of round chambers,(I never have checked for that) I'd just contact the manufacturer and ask him what he thinks. First check with a good gunsmith, and get his opinion, preferably in writing. This will give you some leverage in dealing with the manufacturer, if it should be needed.
Hope this relieves your mind somewhat.
Paul B.
Paul B. is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:58 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07427 seconds with 7 queries