The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old November 11, 1999, 01:24 PM   #1
Mikie
Senior Member
 
Join Date: October 19, 1998
Location: Eastern MA, USA
Posts: 228
Can someone explain the difference between these types of "jacketed" bullets? I always look for the best deals in bullets for reloading 40 and 45 and see that brands like Rainier are listed as electroplated. Are electroplated not as strong a bond over the lead as jacketed? At higher velocities will the electroplate come off in your barrel? Any comments on cheaper brands such as Montana Gold, Rainier, Berry's etc would be appreciated. Also Remington Golden Sabres are listed as "brass" jacketed. How does this compare to other jacketed rounds from Remington and Winchester?

Thanks,

Mikie

------------------
Mikie is offline  
Old November 11, 1999, 09:11 PM   #2
karlfitt
Member
 
Join Date: October 11, 1999
Location: Loveland,CO,USA
Posts: 34
Electroplated brass chemically bonds with the lead. It will NOT come off. It is thinner than a standard jacket, but I don't think that matters. The triton cartridges I use that use Rainer bullets have not left any lead in my barrel.

Karl
karlfitt is offline  
Old November 11, 1999, 09:32 PM   #3
Badger
Member
 
Join Date: September 14, 1999
Posts: 18
I've been using Berry plated bullets in .357 and .44 mag with no leading problems.My understandng is that the plating on these are not as thick as a jacketed bullet and should not be loaded to velocities exceeding 1100 fps although some of the loads I used exceeded that and I still had no problems. I don't see the value in a copper wash bullet as it does nothing to prevent leading.
Badger is offline  
Old November 12, 1999, 09:20 AM   #4
WalterGAII
Junior member
 
Join Date: November 7, 1999
Posts: 1,516
I've been shooting 160gr. plated bullets from West Coast Bullets at 1200fps+ through a compensated, .400 Cor-bon Accu-Match barrel in my Glock 21. Great accuracy out to 100 yds, and I haven't noticed any leading or copper fouling. (I clean pretty well after shooting 200 rounds or so.)

------------------
Shoot to kill; they'll stop when they're dead!
WalterGAII is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:52 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06702 seconds with 9 queries