The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old October 17, 1999, 04:37 PM   #1
TMC
Member
 
Join Date: November 7, 1998
Posts: 92
I'm having a hard time finding the answer to this problem. Many magazine article and gun smiths say that you can run 9x23 in a 38 Super chamber. If so can you use 9mm dies to reload 38 super cartidges? Dillon says that thier 9mm dies are good for 9x19 and 9x23 but were kinda lost when asked about 38 super. They do have a separate 38 Super die set. Many brass makers say the 9x23 will work for 38 super if you have the right extractor. Any info would be appreciated.
TMC is offline  
Old October 18, 1999, 03:30 PM   #2
John Lawson
Senior Member
 
Join Date: August 28, 1999
Posts: 281
Be careful here! A correct extractor is a place to start, but if the brass pushes too far into the barrel you may get excess headspace problems. Some .38 super barrels position (chamber)on the semi-rim and others on the mouth of the case. The 9X23 is a round that positions on the mouth. So, it depends on the individual barrel you have.
And finally, some super chambers are pretty large in diameter. I suggest that you test on a Ransom Rest and mike the cases.
John Lawson is offline  
Old November 11, 1999, 06:25 PM   #3
ghostsix
Member
 
Join Date: November 3, 1999
Location: u.s.
Posts: 45
.38 Supers have used the mouth for headspace for many years.It does pay to check.
ghostsix is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:53 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05769 seconds with 9 queries