The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old May 13, 1999, 10:01 PM   #1
Michael Carlin
Senior Member
 
Join Date: October 13, 1998
Location: Fredericksburg, VA USA
Posts: 193
I need a .224 collet bullet puller to correct a mistake. The old CH I have (circa 1984-5) is a fine tool, but I only have a .308 collet.

Suggestions as to where I might purchase a .224 collet or a reasonably priced entire collet puller would be appreciated.

yours in marksmanship


michael

[This message has been edited by Michael Carlin (edited May 13, 1999).]
Michael Carlin is offline  
Old May 14, 1999, 08:07 AM   #2
fal308
Staff Alumnus
 
Join Date: October 12, 1998
Location: Missouri
Posts: 1,986
You might try Midway. They have collets. www.midwayusa.com
fal308 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:01 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.08406 seconds with 7 queries