The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old February 26, 2006, 11:31 AM   #1
an82cj7
Member
 
Join Date: January 26, 2006
Posts: 17
trigger on 03

I have been working on a 03 springfield and would like to keep it stock but the trigger leaves a little to be desired the pull is verry stiff and the free travel is quite long what can i do to fix this with out going to a timley trigger?
an82cj7 is offline  
Old February 26, 2006, 07:05 PM   #2
DnPRK
Senior Member
 
Join Date: August 24, 2001
Location: LC, Ca
Posts: 1,778
The 03 has a 2 stage trigger and is not a target quality trigger. However, it can be tuned so it doesn't take 2 men and a boy to pull.

I assume you have completely disassembled, cleaned and lightly lubed the trigger assembly and bolt. If not, do so.

With the barreled action out of the stock, the next step is to observe how the sear and sear mating surface on the firing pin rod fit together. I color the mating surfaces of the sear and firing pin rod with permanent marker. Then cock and dry fire several times. Remove the bolt and observe the wear pattern on the sear and firing pin rod. Ideally, the wear should be evenly distributed across both surfaces.

Heavy trigger pull is typically caused by contact on only on the right or left edge of the sear surface. If this is the case, you'll need to stone the sear until it bears evenly across the firing pin rod as viewed from above. Use a fine arkansas stone held square to the surface and go slowly. You do not want to alter the sear angle as viewed from the side, nor do you want to round the surface as viewed from above.
DnPRK is offline  
Old February 27, 2006, 10:08 PM   #3
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,979
Please do not remove too much metal from the sear or cocking piece. And when you have smoothed up the pull, MAKE SURE that you have sear reset. To do this, cock the bolt, set the safety, pull the trigger hard and then release it, and move the safety to OFF. If the firing pin falls, you took off too much. Do NOT try to mess with the safety and ruin it, too. Buy a new sear and new firing pin rod.

Jim
__________________
Jim K
James K is offline  
Old February 28, 2006, 06:43 PM   #4
an82cj7
Member
 
Join Date: January 26, 2006
Posts: 17
I have a 400 grit diamond hone i plan on using to clean up the sear and cocking piece would this be too agressive?
an82cj7 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:03 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06541 seconds with 7 queries