The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old February 22, 2006, 10:14 PM   #1
Hankster
Member
 
Join Date: February 20, 2006
Location: Ontario Canada
Posts: 36
40 cal and my Ruger P94

Members, I have a problem. First, let me say that I have been reloading and bullet casting for at least 20 years. Secondly I am Canadian, don't hold that against me, and thirdly I have a problem finding the ideal load for my 40 Ruger P94. I have tried just about every kind of powder, and in different amounts. I have cast 175 grainers from a Lee mold out of wheelweights, and put very little taper crimp. At 60 feet my shots are all over the place. I would like to think that I have tried everything I could think of, with no positive results. This week I am going to try to load a harder cast bullet with 4.6 grains of Bullseye as well as Hornady JHP (175 grs). My fingers are crossed. Can you help this very frustrated Canadian? I will be awaiting any suggestions.
Hankster is offline  
Old February 23, 2006, 09:48 AM   #2
Ruger4570
Senior Member
 
Join Date: April 3, 2005
Location: Rochester, New York
Posts: 2,136
Have you tried jacketed bullets at this point. I was just wondering as it might give you a benchmark of accuracy. I have cast for more years than I want to think about and have found bullets from some molds just won't shoot as well as slugs from others. Lee makes good molds for the most part and I use one of theirs for my 45LC and it shoots the best of my 3 other molds. I cast straight wheelweights mostly, but due to the imprecise nature of the mix, I sometimes add a little leadless solder to the mix as it is almost pure tin. This helps to make the bullets cast better. You might want to slug your barrel and compare it to the diameter of your bullets too. Lately I have been sizing and lubing my bullets as normal then using some of Lee's tumble lube also. There seems to be, in 2 of my guns (45LC/45-70) an improvement in accuracy and leading is almost non-existant. Seeing you are in Canada and you have a big supply of snow, you can also do what I do when casting. I get a bucket full of clean snow and add enough cold water to get a slush. I drop my casts directly into this VERY cold water and it does make them measurably harder than air cooled or into just cold water. Hope some of this helps..Good luck with the problem
Ruger4570 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:35 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05423 seconds with 7 queries