The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old March 14, 2000, 09:05 PM   #1
Mike Root
Member
 
Join Date: November 28, 1999
Location: Charleston, sc. us
Posts: 24


George I picked up this High Standard at a gun show for maybe too good a price. It shoots a foot high at 20 feet. How tight is the takedown nut supposed to be? Can I have it too tight? I'm going to loosen it up and try that tomorrow. Mike Root
Mike Root is offline  
Old March 14, 2000, 09:48 PM   #2
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Mike, I don't know that there is a limit to the tightness. Does it group well? You might give a look to the crown. If it does group good you can deepen the rear notch and file down the rear sight if yours isn't adjustable or if you've taken it as far down as it will go. George
George Stringer is offline  
Old March 15, 2000, 12:52 AM   #3
Bud Helms
Staff
 
Join Date: December 31, 1999
Location: Middle Georgia
Posts: 13,013
Mike,

I've used a nickel (maybe it was a penny) to tighten mine It didn't hurt anything, but I don't think it's necessary.

You might want to check real good in the area where the barrel mounts down on the frame and make sure there isn't a small burr or piece of trash lifting it at the front. I suppose that would hinder chambering, but it's worth a look.

Gun Parts Corp has six inch barrels if you're interested. About $65. Mine came without a front sight though, and I had to make one. I just copied the pattern on the four inch barrel. 'Haven't shot it with the new barrel and sight yet.

[This message has been edited by sensop (edited March 15, 2000).]
Bud Helms is offline  
Old March 16, 2000, 09:22 AM   #4
slabsides
Member In Memoriam
 
Join Date: May 27, 1999
Location: Maine
Posts: 614
This is an interesting question, and the answer isn't as obvious as at first might appear. The HS barrel sits in what is essentially a V-block frame, with the front sight on the barrel and rear on the slide. A burr on the frame in front of the attachment point would effectively tip the barrel up, which should raise POI; but it also raises the front sight, which would tend to compensate. The reverse for a burr which tipped the barrel down, behind the attachment screw. What seems obvious...bent barrel causes group movement...on closer examination becomes much more complex. I'd remove any burrs, on principle, but I'd also be prepared to replace the front sight with a higher blade. On a used gun, it's a good bet that someone tried to 'adjust' a high-grouping gun by filing down the front sight, which of course is just the opposite of what should be done. slabsides
slabsides is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:28 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07428 seconds with 7 queries