The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old January 19, 2006, 10:48 AM   #1
odtobe
Junior Member
 
Join Date: December 20, 2005
Posts: 4
Charging loads

I am a newbie to the loading thing and am taking every precaution I can. I have a question about loading .40 SW. Every loading manual that I have looked at has recipies on a particular load that I want, however they generally list the weight of the bullet as a JHP, not a FMJ that I will be loading. Can FMJ and JHP loads be interchanged without error, if all of the other components remain the same, and bullet weights are the same?

thanks
odtobe is offline  
Old January 19, 2006, 11:01 AM   #2
DAVID NANCARROW
Senior Member
 
Join Date: November 5, 2000
Location: TEXAS
Posts: 1,543
Two things you can do:
1. Contact the bullet manufacturer for recommendations.
2. Use the starting load for the JHP and work up slowly. The FMJ might have a bit more bearing surface and might make pressures spike a bit early when you near the maximum charge.
DAVID NANCARROW is offline  
Old January 19, 2006, 12:20 PM   #3
Leftoverdj
Senior Member
 
Join Date: October 15, 2004
Posts: 934
Since you are new to reloading, a switch from one jacketed bullet to another should not be a concern. You should still be working with starting level loads, or as little up from that as is needed to cycle your guns. That leaves more than enough safety margin to swallow as small a change as switching from one bullet to another of the same weight.

Such a change might make a difference with a max or near max load but is of no concern in moderate loads. You do need to watch overall length though. Generally, FMJs need to be a bit longer to have the same seating depth.
Leftoverdj is offline  
Old January 22, 2006, 12:18 PM   #4
WESHOOT2
Senior Member
 
Join Date: February 20, 1999
Location: home on the range; Vermont (Caspian country)
Posts: 14,270
millions later

Sized case, CCI500, 180g FMJ or TCJ-FP, OAL 1.130"+/-.005", 6.0g Alliant Power Pistol.

Finish using a LEE Carbide Factory Crimp die.

Av = 890--920fps, based on specific gun.
__________________
.
"all my ammo is mostly retired factory ammo"
WESHOOT2 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:40 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05840 seconds with 9 queries