The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old February 2, 2000, 03:19 PM   #1
hkg3
Senior Member
 
Join Date: October 9, 1999
Location: Kalifornia, on my way to Arizona
Posts: 1,149
Got a new Redhawk, I'm doing mo own "trigger job" by hand polshing only, I'm not changing angles. Are there any dangers with "overpolshing."

------------------
Gun control started the Revolutionary War!..."itcta alea est"

hkg3 is offline  
Old February 2, 2000, 09:43 PM   #2
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
HKG3, yes there is. If you reduce the engagement too much the gun may not cock. DA revolvers are really not the best guns to do your first trigger work on. There are a lot more parts involved than just the trigger/sear/hammer train. If you do go to far though, I'm sure that your local smith will be happy to help you. George
George Stringer is offline  
Old February 6, 2000, 08:46 AM   #3
Ken in Iowa
Member
 
Join Date: November 18, 1999
Location: Montezuma, IA
Posts: 70
My Redhawk came from the factory with an eight pound single action pull.
Redhawks are very touchy to get a decent pull weight. The single spring system is a pain. Changing angles brings a lighter pull with a host of other problems. Push off and hammer catching the sear as the trigger is pulled are two.
Fine stones for polishing every moving part can make a big difference. Don't forget spots where the rame rubs against the hammer. Follow with a good oil for lubrication.

------------------
Ken in Iowa is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:00 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06079 seconds with 9 queries