The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Reply
 
Thread Tools
Old December 29, 2005, 07:58 PM   #1
Old Dragoon
Senior Member
 
Join Date: October 31, 2005
Location: The Republic of Californi
Posts: 581
Kirst Konverter Binding problems......a fix

I had some trouble getting the Kirst Konverter to "drop In" my new '58 on half cock. It would drop in with the hammer just pulled back enough to drop the cylinder lock but not on halfcock. It would bind up and not turn and the cylinder pin would not do more than start into the cylinder. I took the recoil shield out and tried to just install the cylinder, same problem. I got to looking at the hand and it was the problem I looked at the hand of the other two '58's and this one had a bump on the top of it and it wasn't shaped like the others. I dis-assembled the pistol and sure enough the hand was very different on the top and the front(pawl end). I took a stone and a hard file to it and shaped it like the other two. re-assembled the pistol. This time the Konverter dropped right in on half cock, and the cylinder pin slid right in. Now all three have the same shape hand.

If you have a binding problem trying to drop in a Kirst Konverter on Half Cock, try my method first and it just may be a deformed hand.
Old Dragoon is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:28 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06816 seconds with 7 queries