The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old January 1, 2000, 07:29 PM   #1
Daren Thompson
Senior Member
 
Join Date: December 6, 1998
Location: Elizabethtown,KY,USA
Posts: 457
I just bought a Kimber Classic Stainless Target. I have shot around 100 rounds with no malfunctions of any kind. Accuracy is good. However today I noticed a small nick, almost like a flake of metal missing, in the rifling groove. Accuracy seems not to be affected and the nick is about 1/4 inch from the end (exit). I plan to take the gun back to the dealer Monday. What could have caused this? Is this something the gun should go back to the factory for? I have fired FMJ, Federal Hydr-Shok, and homemade cast lead. Could this have been caused by a particular bullet?

Info is greatly appreciated as this is my new baby

Later
Daren
Daren Thompson is offline  
Old January 1, 2000, 09:46 PM   #2
Bennett Richards
Senior Member
 
Join Date: November 14, 1998
Location: Carlsbad, CA USA
Posts: 343
Nothing you fired could have done that... probably will not affect anything... but no excuse for poor quality control. If Kimber gets enough weapons back from dealers and dealers start getting ****** off then Kimber will be forced to clean up its act.

Send it back!

Ben
Bennett Richards is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:53 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06063 seconds with 7 queries