The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old December 20, 1999, 02:36 PM   #1
Lavan
Senior Member
 
Join Date: December 10, 1999
Location: California
Posts: 2,107
On another section of the forum, I asked about the durability of the finger type bushing on the Series 70 1911. Apparently my concern is valid as most replies were to change to the solid bushing.
I have a catalog coming from Brownell's who state that they stock both the "drop in" as well as the "needs fitting" bushing.
One member I e-mailed suggested using the drop-in as it will still shoot better than one can hold.
This gun is a Gold Cup that shoots one hole 10 shot groups at 21 feet.
Do the rest of you also suggest the drop-in?
And.....what type of fitting is needed on the fitted type? I am handy with fixing guns and have done stuff like fit SAA triggers to hammers and minor stuff like that. Would it be foolish to attempt to fit a barrel bushing?
Lavan is offline  
Old December 20, 1999, 05:26 PM   #2
JoeHatley
Senior Member
 
Join Date: July 1, 1999
Location: Iowa
Posts: 2,135
If you are not familiar with fitting a bushing and you want to do it yourself, I would suggest taking carefull measurments and ordering a Biley from Brownells.

#4 at this site shows much of what is involved with fitting a solid bushing:
www.larue-targets.com/Extreme1911.html

Good Luck...

Joe


------------------
Go NRA
JoeHatley is offline  
Old December 20, 1999, 11:57 PM   #3
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Lavan, I agree with Joe if this is going to be a one time job for you. If you plan on doing your own work when you can however you might look at getting an adjustable reamer and using the WCPI gunsmith fit bushings. George
George Stringer is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:46 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06521 seconds with 7 queries