The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old December 13, 1999, 06:44 PM   #1
plateshooter
Senior Member
 
Join Date: September 29, 1999
Location: N.E. Ohio
Posts: 522
I just purchased a EAA Witness 45 with the fixed rear site. I would like to put an adjustable on it. The slide has the dovetail cut close to the rear of the slide, and some of the replacement sites have the dove tail twards the front of the site, which would cause the site to hang over the rear of the slide. Has anyone put an adjustable on one of these guns, and what kind did you use?
Thanks for your replies

------------------
Good shootin to ya
Plateshooter
plateshooter is offline  
Old December 13, 1999, 08:55 PM   #2
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Plateshooter, the MMC is a nice sight for the Witness. I've put it on a couple of pistols for customers. It isn't much bigger than the factory sight. The others, Bo-Mar, Mec-Gar, etc. I always install as melded to the slide. George
George Stringer is offline  
Old December 13, 1999, 09:22 PM   #3
plateshooter
Senior Member
 
Join Date: September 29, 1999
Location: N.E. Ohio
Posts: 522
Thanks for the reply George. Could you tell me where I might be able to purchase the MMC site? I will try to find a MMC web site. What does melded to the slide mean?
Thanks

------------------
Good shootin to ya
Plateshooter
plateshooter is offline  
Old December 18, 1999, 01:56 PM   #4
Kernel
Senior Member
 
Join Date: November 21, 1999
Location: Madison, WI.... "78 Square Miles Surrounded by Reality"
Posts: 922
Brownells carries the complete line of MMC sights. They also carry a ton of parts for the Witness, including: frames, slides, barrels, comps, caliber conversion kits, triggers, etc. Below is a link to thier searchable web catalog. -- Kernel

www.brownells.com

[This message has been edited by Kernel (edited December 18, 1999).]
Kernel is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:00 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05880 seconds with 7 queries